南昌附近有没有服务

Dongyuan Electric Machinery Co., Ltd
Contact Dongyuan
    • Fax: 0373-3356116
    • Tel: 0373-3383880 (Hao SIR)
    • Mobile phone: 15603730073
    • Mobile phone: 18037399900
    • Email: [email protected]
    • Address: Muye Industrial Park, Xinxiang City
    •  Click here to send me a message  Click here to send me a message

Operation method of vibration motor

  Vibration motor After being sent to the customer site, many customers will not be able to operate. Incorrect operation will not achieve the desired screening effect. The vibration motor manufacturer will read the instruction manual of ultrasonic system according to the requirements of the report. The instructions are quite detailed. After all, the vibration motor system belongs to the scope of electrical operation and is slightly more complex than the mechanical principle to avoid unnecessary ultrasonic loss and unnecessary detection failure.
 
Motor operation method
 
1. The ultrasonic system should use a complete set of tests. Many customers reported that the ultrasonic system did not work properly after maintenance. The reason is that if there is no problem after testing the power box, but the sensor is not checked, the sensor is damaged. According to the problem, the power box could not be found.
 
2. The power supply and voltage of the operating system of the ultrasonic system are 220V AC. The ultrasonic output power is connected to the transducer through the data line from the back panel of the power box. Red is positive. Pay attention to the voltage pole when connecting. Error.
 
3. When the shielding effect is achieved, the power block should be adjusted as much as possible, and the current should not exceed 0.4. Avoid unnecessary energy consumption and unnecessary power over-current damage.
4. When the power grid is not shielded, do not open the ultrasonic system, otherwise the inverter will be damaged due to over-current.
 
5. The vibrating motor can stretch the screen to achieve the ideal screening effect. Otherwise, the ultrasonic output and vibration effect will be affected by the screen, which will seriously affect the screening effect and screening output.
 
6. The air plug screw on the transducer must be tightened and the data line should be checked regularly for damage. Aviation joints and data lines must be wrapped with insulating tape to prevent dust. If the aviation plug is not tightened, the vibration wave energy of ultrasonic vibration screen cannot be transmitted. Loss of vibration effect.
 
7. Material to prevent material from entering the power box.
 
8. If the vibration motor has too much noise or the fan does not move, please stop working immediately and check the cooling fan. Please pay attention to ventilation when using the power box.
 
Each group includes resonant power supply, oscillator and power grid. Please use a combination of numbers for better results. Do not mix with other ultrasound.
Related articles:
Last article: Vibration motor end cover Next: no more
 Back to the top
Copyright © 1999-2013 Xinxiang Dongyuan Machinery Co., Ltd . yuicp No. 08102388 111