南昌附近有没有服务

Dongyuan vibration motor announcement:
Contact Dongyuan
    • Fax: 0373-3356116
    • Tel: 0373-3383880 (Hao SIR)
    • Mobile phone: 15603730073
    • Mobile phone: 18037399900
    • Email: [email protected]
    • Address: Muye Industrial Park, Xinxiang City
    •  Click here to send me a message  Click here to send me a message

How to install vibration motor?

In order to make the vibration motor play a greater role, the vibration motor will be installed in different positions to improve the screening efficiency and screening accuracy. It can quickly finish the appearance quality of irregular parts and improve the crushing or mixing results.

1. Both sides: this installation method is also a relatively adopted method for the vibration motor of linear vibrating screen equipment. It is usually used when we have restrictions on the overall height of the equipment, but there is no limit on the width of the equipment.

For example, due to the special requirements of some materials, the discharge port of the equipment cannot be too high from the ground. In this case, if we install the vibration motor at the bottom or top of the linear screen, the overall height of the equipment will be difficult to control. Generally speaking, the height of the screen box of the linear screen is usually certain, so we can not adjust the height of the screen box. This is to consider installing the vibration motor on both sides of the linear screen, which can greatly reduce the overall height of the equipment, and does not affect the working efficiency of the equipment.

 Real shot of vibration motor

2. Top: this installation method is not common in dzsf series linear vibrating screen, and few people do so. However, this installation method is usually adopted for ZSG linear screen. If the customer has restrictions on the height and width of the discharge port of the linear screen equipment, the vibration motor can not meet the requirements whether it is installed at the bottom or on both sides In this way, the width of the equipment will not be increased, and the height of the equipment outlet will not be reduced.

The roughness of the connection plane between the vibration motor and the vibration machine should be 3. 2 or higher

1. If the insulation of winding is affected by damp, the corresponding method shall be adopted to deal with the insulation resistance of 500V megger to check the insulation resistance of winding. When it is close to the working temperature (70 ℃), it shall not be lower than 0. 38 megohm, otherwise it should be dried.

2. Check whether the cable is in good condition and replace it in time in case of breakage.

3. Whether the body is in good condition. If it is damaged, please contact us for replacement.

 Structure of vibration motor

When the vibration motor is installed on the vibration machine, the foundation bolt of the vibration motor must be tightened, and an elastic washer must be added under each nut.

In the initial stage of operation of the vibration motor, due to the running in between the bolts, nuts of China vibration machinery network and the base plane, the fastening force will be reduced and small looseness will occur. Therefore, the foundation bolts of the motor should be tightened several times in the initial stage of operation, once a day at the beginning, and once a week after two weeks.

After being installed in place, there should be cable clamping device on the body and foundation. The cable between the two should be naturally suspended, and the total length should be 300-500mm. The bending radius of the natural suspension should refer to the two vibration motors of the linear vibration equipment. When the two vibrating motors of the linear vibration equipment work at the same time, it is necessary to check whether the direction of the two vibration motors is opposite. Otherwise, the power phase sequence of one motor should be changed to make the two vibration motors turn in opposite direction, so as to ensure the uniform direction of materials.

Related articles:
 Back to the top
Copyright © 1999-2013 Xinxiang Dongyuan Machinery Co., Ltd . yuicp No. 08102388 111